EMI & EMC Overview - Electromagnetic Compatibility

                                                      EMI & EMC Overview

Definition [IEC 61000-1-1]

The ability of a device, unit of equipment, or system to function satisfactorily in its electromagnetic environment without introducing intolerable electromagnetic disturbances to anything in that environment.

A system is said to be electromagnetic compatible if 

  1. It does not cause interference with other systems

  2. It is not  susceptible to emission from other systems

  3. It does not cause interference with itself.


For more details about EMC please watch this video. This will help you to understand the basics about EMC.
It will also help you understand about EMI.

Thanks !






Popular posts from this blog

LTspice - LM317 Voltage Regulator Design & Simulation

 Hello Reader, This article is very useful for those who are persuing the career in Electronics Circuit Design. LM317 is 3 terminal device which can be used to power up small loads up to 1.5A. Below is the features of LM317. 1• Output voltage range adjustable from 1.25 V to 37 V • Output current greater than 1.5 A • Internal short-circuit current limiting • Thermal overload protection • Output safe-area compensation VO is calculated as shown below. IADJ is typically 50 µA and negligible in most applications. VO = VREF (1 + R2 / R1) + (IADJ × R2) Please watch below video to understand circuit design & Simulation. https://youtu.be/euX9KndZmtc
Read more

Op-Amp Shunt Voltage Regulator Design

Image
Op-Amp Shunt Voltage Regulator Design Fig.1 In this blog i will be explaining about the design of a Opamp shunt voltage regulator. Pros and Cons of the shunt voltage regulator will be discussed. The complete explanation can be watched in video below. Working :  Due to variation in input voltage Vin or load current IL there is a change in output voltage of shunt regulator. Terminology Used : Vin = Input Voltage Vo =Output Voltage Vz = Fixed Reference Voltage R1 & R2 = Sample or Voltage monitoring Circuit Opamp- Error Amplifier Rs = Input Current Limiting resistor Vs = Voltage across Rs Transistor = It is used to regulator the output voltage RL = Load Resistance IL = Load current Is = Source Current Ic = Transistor collector current V+ = Voltage at Non Inverting Terminal V- = Voltage at Inverting Terminal Case 1: If the output voltage increases due to sudden change in input voltage or load current. Since sample circuit monitor the output voltage using voltage divider R1 and R2. The V
Read more